Community Forum

Hello,

Im looking for a solution to create a inline border gradient shader without UVs depending on the outer mesh edes, any idea?

Thank u!

I'm actually looking for the same thing, except I want it to create that border gradient effect around the UV islands.

But I also would need the effect your describing here, as I looked into it with Amplify in the past. I didn't dig deep but I never found a solution when I looked.

Subscribing to this thread. I'd like to see a solution for this, as well.

dink wrote:I'm actually looking for the same thing, except I want it to create that border gradient effect around the UV islands.

But I also would need the effect your describing here, as I looked into it with Amplify in the past. I didn't dig deep but I never found a solution when I looked.

Subscribing to this thread. I'd like to see a solution for this, as well.

We don't think this is possible to calculate only with vertex data, without using any type of additional information but will try to investigate a bit on that and post if we find any solution.